Filter
Top Products
Streamer GT SIR-SL1C User Guide
5
• When replacing a fuse, use only a new one with
the proper rating. Using a fuse with the wrong
rating may cause the unit to malfunction.
• To prevent a short circuit when replacing a fuse,
rstdisconnectthewiringharness.
Note
If the unit doesn’t seem to be working properly:
• Turn the unit’s power off, wait 5 -10 seconds, then
turn the power on again.
• If the unit still malfunctions, turn the unit’s power
off, remove it from the cradle, wait 5 -10 seconds,
replace it in the cradle and turn the power back on.
If the problem persists, contact Technical Support.
FCC Warning
This equipment may generate or use radio frequency
energy.Changesormodicationstothisequipmentmay
causeharmfulinterferenceunlessthemodications
are expressly approved in this user guide. The user
could lose the authority to operate this equipment if an
unauthorizedchangeormodicationismade.
Note
This equipment has been tested and found to comply
with Part 15 of the FCC Rules. These rules are
designed to provide reasonable protection against
harmful interference. This equipment may cause
harmful interference to radio communications if it
is not installed and used in accordance with these
instructions. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and Streamer GT Receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the Streamer GT
Receiver is connected
• Consult the dealer or an experienced radio/TV
technician for help.