Filter
Top Products
17
TROUBLE SHOOTING
Sometimes a simple operational error or a mistake in the wiring can appear to be a problem with
the unit. Before having the unit serviced, refer to the troubleshooting chart below.
Symptom Cause Solution
The volume control is turned down.
Turn up the volume control.
The compact disc
does not
play when
inserted into the
unit.
The power connections are
not wired
correctly.
Check the +12V and ground
connections.
The vehicle ignition is switched off.
Switch the ignition to the “ON”
or “ACC” position.
No power.
The fuse is blown.
Replace the fuse with another 15
A
fuse.
The unit does not
work properly
(Eject, Load, Play)
The microcomputer has been
affected
by electrical noise.
Press RESET button.
The road surface is rough.
Wait for the road surface to
improve before playing a disc.
The unit is not mounted securely.
Install the unit securely. Be sure
to
use the rear strap if the vehicle
does not provide support
for the
rear of the unit. (See page 21)
The sound from the
CD player skips.
The disc is defective.
Try another disc.
If it plays properly, the first disc
may be defective.
The disc is dirty.
Clean the disc as explained on
page 3.
No radio reception.
The antenna cable is not connected.
Insert the antenna cable firmly
into
the antenna jack on the unit.
The radio does not
stop on any
stations when
automatic tuning is
used.
The signals are weak.
Select a station using manual
tuning.