Filter
Top Products
Hex head bolt
and washer
Bracket
Bracket
4
2
Attach a mounting bracket to each side of the unit, using
the hex head bolts and washers.
Mount the unit in place, using two self-tapping Phillips head
screws.
Use RTV (silicone sealer) on screw threads or around
the holes to prevent moisture intrusion.
Set the anti-vibration springs to position "V"
as shown below .
Determine the mounting location and drill two mounting holes.
3
5
PROCEDURE FOR VERTICAL INSTALLATION
Note
If the anti-vibration spring position has been changed and verified for vertical mounting (as shown on page 4), start with step 2.
1
WARNING
Never mount the unit near the fuel tank.
Self-tapping
Phillips head
screw
Bracket
NOTE:If mounting surface is carpeted, use caution
when drilling holes to prevent drill bit from
catching on carpet. Cut holes in carpet
before drilling into sub-surface.
POSITION
"V"
Drill holes 1/8" (4mm) in diameter.
Carpet
Hex head bolt
and washer
Bracket