Filter
Top Products
PROCEDURE FOR HORIZONTAL INSTALLATION
4
INSTALLATION
The unit can be installed horizontally (position H), or vertically at a 90° angle (position V). The position of the built-in anti-vibration
springs (left and right side), must correspond to the mounting position chosen. If the springs are not set correctly for the type of
installation chosen, the anti-vibration compensation will not be effective and vibration may cause the disc to skip.
HORIZONTAL INSTALLATION
Set the anti-vibration springs to
position "H".
VERTICAL INSTALLAITON
Set the anti-vibration springs to
position "V".
POSITION
"H"
Drill holes 1/8" (4mm) in diameter.
1
2
3
Attach a mounting bracket to each side of the unit, using the
hex head bolts and washers.
Determine the mounting location and drill two mounting holes.
Secure the unit in place, using two self-tapping Phillips head
screws.
Use RTV (silicone sealer) on screw threads or around
the holes to prevent moisture intrusion.
Self-tapping Phillips head screw
WARNING
Never mount the unit near the fuel tank.
Bracket
Hex head bolts
and washers
NOTE: Make sure anti-vibration springs
are set to position "H" as shown
above.
POSITION
"V"
C
O
M
P
A
C
T
D
I
S
C
C
H
A
N
G
E
R
D
I
G
I
T
A
L
A
U
D
I
O
6
D
I
S
C
A
C
C
3
1
BY AUDIOVOX
Bracket
C
O
M
P
A
C
T
D
I
S
C
C
H
A
N
G
E
R
D
I
G
I
T
A
L
A
U
D
I
O
6
D
I
S
C
A
C
C
3
1
BY AUDIOVOX
Bracket
NOTE:If mounting surface is carpeted, use caution
when drilling holes to prevent drill bit from
catching on carpet. Cut holes in carpet
before drilling into sub-surface.
Carpet