Filter
Top Products
Page 14
Setting up the Inflatable Home Theater for Front and Rear Projection
Projector Distance
• Typically, set up the projector a distance (1x – 1.5x) the
diagonal from the screen.
• In general, for a 16:9 screen ratio use 1.15x the diagonal for
projector distance. For 4:3 screen use 1.25x.
• Follow the projector manufacturer’s instructions.
Projector Angle
• Attempt to position the projector so that it is
parallel to the inflatable screen.
• Care should be
taken so that the
projector is aligned
both horizontally
and vertically to the
front of the inflatable
screen.
• If your projector has
a keystone
adjustment feature,
this may be used to
correct for the angle
being slightly off.
Rear Projection Setup
• To use the inflatable screen with the projector placed
behind the screen, first lift the black light guard up so
that it does not block the white screen material.
• For nighttime video viewing, the black light guard can
be removed from the frame.
• There are two grommets located in the lower corners
of the light guard. To use the light guard to block
overhead light while using a rear-projector, use the
grommets to tie the light guard horizontally, so that it
blocks unwanted light, but allows the image from the
projector to be shown on the screen.
• Adjust your projector to rear-projection mode following
the manufacturer’s instructions.
• Use the white nylon ropes and ground stakes to keep the
light guard in position for rear projection.
Light Guard
Grommets