Filter
Top Products
16
CONFIGURATION
SWITCHED (default)
Overview of Dante Network Modes
The Dante network interface has two ports (Primary and Secondary) to provide flexible routing and configuration options for network signals.
Three selectable Dante network modes are available to control signal routing from the receiver ports to the Dante network.
Network Mode
Port Function and Signals
Application
Secondary Primary
SWITCHED
Shure Control
Dante Audio and Control
Shure Control
Dante Audio and Control
For single network Installations of star or daisy-chained
networks.
REDUNDANT AUDIO Dante Redundant Audio
Shure Control
Dante Audio and Control
Primary and Secondary ports are configured are 2 separate
networks. The Secondary port carries a backup copy of the
Primary digital audio signal.
SPLIT Dante Audio and Control Shure Control
Primary and Secondary ports are configured are 2 separate
networks to provide isolation between control signals and
audio signals.
Setting the Dante Networking Mode
Select a Dante mode to configure network signal routing on the Primary and Secondary ports.
Set all receivers on the network to the same mode.
Note: Remove network connections from the receiver before changing the mode.
1. From the receiver menu: DEVICE UTILITIES > NETWORK > CONFIGURATION
2. Use the control wheel to select a mode (SWITCHED, REDUNDANT AUDIO, SPLIT)
3. Press ENTER to save.
4. Cycle receiver power to enable the mode change.