Sherwood RD-6500 Stereo System User Manual


 
ENGLISH
17
Adjusting the speaker settings
Press the SPEAKER MODE button for
more than 2 seconds to enter the front-
center-rear speaker mode.
6
Select the desired speaker setting.
7
• The front-center-rear speaker setting is displayed.
• When the SPEAKER button is set to off or the 6 CH
DIRECT is selected as an input source, the speaker
mode function cannot be available.
• When it is in the stereo, only the subwoofer setting
can be adjusted.
• Adjust the settings of front, center ,rear speakers and
subwoofer connected.
• If the speaker setting is adjusted to “S”, the low range
bass sound of the channel(s) is redirected to the
subwoofer or the front channels and if the speaker
setting is adjusted to “N”, the sound of the channel(s)
is redirected to other channels.
• Each time this button is pressed, one of 11 different
speaker settings is selected and displayed for 8
seconds as follows;
FL-CS-RS, FL-CL-RS, FL-CL-RL,
FL-CL-RN, FL-CS-RL, FL-CN-RL,
FL-CS-RN, FL-CN-RS, FS-CS-RS,
FS-CS-RN and FS-CN-RS
• In the displays, F stands for Front, C for Center, R
for Rear, L for Large, S for Small and N for None.
• When judging whether a speaker is Large or Small,
please note that a standard large speaker can fully
reproduce sounds below 80 Hz.
• The following speaker settings cannot be selected.
Front :Small, Center : Large and Rear : Large(FS-
CL-RL) or Center : None and Rear : None(CN-RN)
setting.
SPEAKER
MODE
Select the desired subwoofer setting.
9
• The desired speaker setting is memorized and then it
enters the subwoofer mode.
• If the speaker setting display disappears, start from
the above step 6 again.
Each time this button is pressed, the subwoofer setting
changes and is displayed for 8 seconds as follows;
SUB W(oofer) - Y(es): When using a subwoofer.
SUB W(oofer) - N(o) : When not using a subwoofer.
• In case that the front speaker is set to “S”, the
subwoofer is automatically set to “Y”.
MEMO/ENTER
MEMO/ENTER
Memorize the desired speaker setting
while it is displayed.
8
ADJUST
ADJUST
• If the subwoofer setting display disappears, start
from the above step 6 again.
• Each time this button is pressed briefly, the front-
center-rear speaker or subwoofer setting is displayed.
Memorize the subwoofer setting while it
is displayed.
10
Checking the speaker setting
SPEAKER
MODE