Filter
Top Products
ENGLISH
17
LISTENING TO RADIO BROADCASTS
Auto tuning
• Each time this button is pressed, the band changes as
follows ;
FM ST FM MONO AM
("ST" lights up) ("ST" goes off)
• When FM stereo broadcasts are poor because of weak
broadcast signals, select the FM mono mode to reduce
the noise, then FM broadcasts are reproduced in
monaural sound.
• Manual tuning is useful when you already know the frequency of the desired station.
• After selecting the desired band, press the TUNING UP/ DOWN buttons repeatedly until the right frequency has been reached.
Manual tuning
• The tuner will now search until a station of sufficient
strength has been found. The display shows the tuned
frequency and "TUNE".
• If the station found is not the desired one, simply repeat
this operation.
• Weak stations are skipped during auto tuning.
1. Select the desired band.
2. Press the TUNING UP/DOWN buttons for more than 0.5 second.
Auto presetting
• Auto presetting function automatically searches for FM stations only and store them in the memory.
• While listening to FM radio broadcasts, press and hold down the MEMORY button for more than 2 seconds.
• Then "AUTO MEM" flickers and this receiver starts auto
presetting.
• To stop auto presetting, press this button again.
• Up to 30 FM stations can be stored.
Notes:
• FM stations of weak strength cannot be memorized.
• To memorize AM stations or weak stations, preform
"Manual presetting" procedure with using "Manual tuning"
operation.
RX-4503(A) 2008.8.12 3:43 PM 페이지 17