Filter
Top Products
ENGLISH
13
Operations
LISTENING TO A PROGRAM SOURCE
Before operation
• This unit enters the standby mode and the STANDBY
indicator lights up. This means that the receiver is not
disconnected from the AC mains and a small amount of
current is retained to support the operation readiness.
• To switch the power off, push the POWER switch again.
Then the power is cut off and the STANDBY indicator
goes off.
• Each time the POWER ON/STANDBY button on the front
panel is pressed, the receiver is turned on to enter the
operating mode or off to enter the standby mode.
• On the remote control, press the POWER ON button to
enter the operating mode or press the STANDBY button to
enter the standby mode.
• In the standby mode, if the INPUT SELECTOR button on
the remote control is pressed, the receiver is turned on
automatically and the desired input is selected.
• When selecting the EXTERNAL IN, 6 seperate analog
signals from the component connected to this input pass
through the tone and volume circuits only and can be
heard from your speakers.
• These analog signals can be heard only, not recorded.
• Each time the INPUT SELECTOR knob is rotated, the
input source changes as follows :
TUNER CD TAPE AUX
(Frequency display)
EXT IN BT IN F AUX
• Each time the BAND button or the TUNER button is
pressed, the band changes as follows:
FM ST FM MONO AM
or
POWER
1. In the standby mode, turn the power on.
• Then the corresponding speaker indication ("SPK A or B")
is displayed and the sound can be heard from the
speakers connected to the selected speaker terminals.
• When using the headphones for private listening, press
the corresponding SPEAKER button to switch off both A
and B speakers.
2. Switch the desired speakers on.
3. Select the desired input source.
• Push the POWER switch.
RX-4503(A) 2008.8.12 3:43 PM 페이지 13