Filter
Top Products
ENGLISH
32
OFF : To listen to a program source without the tone effect. ("DIR" indicator lights up.)
ON : To adjust the tone for your taste. ("DIR" indicator goes off.)
Note :
• When the EXTERNAL IN is selected as an input source, the TONE cannot be set to ON.
When the TONE is set to ON to adjust the tone (bass and treble)
Press the ENTER button to enter the tone adjustment.
Press the CURSOR UP()/DOWN() buttons to select the desired tone.
• The tone level can be adjusted within the range of -10 ~ +10 dB.
• In general, we recommend the bass and treble to be adjusted to 0
dB (flat level).
• Extreme settings at high volume may damage your speakers.
• To complete tone adjustment, repeat the above steps
and
.
Press the CURSOR LEFT()/RIGHT() buttons to adjust the selected tone as desired.
When selecting the TONE
When selecting the ROOM EQ mode
• The room EQ is a kind of room equalizer for your speakers. According to the acoustic characteristics of your room
measured by the auto setup, the room EQ automatically adjusts the frequency response of your speakers.
• If you use different brands or sizes of speakers for some channels or have a room with unique acoustic characteristics,
such as walls, furniture, and the dimensions or the shape of the room, we recommend using the room EQ.
Note :
• When playing the 96 kHz PCM (2 channel) digital signals, the room EQ is invalid.
OFF : When turning off the room EQ.
ON (AUTO SET) : To adjust the frequency response of all speakers to the flattest response.
• If you have never performed the auto setup, it will automatically enter the auto setup mode to measure
the acoustic characteristics of your room. In this case, you should perform the auto setup to set the
ROOM EQ to ON. (For details, refer to "When selecting the AUTO SETUP" on page 35.)
RD-6513(A) 2008.8.21 12:20 PM 페이지 32