Filter
Top Products
ENGLISH
20
• While playing digital signals from Dolby Digital or DTS program source or listening in Dolby Pro Logic II Music mode, you
can adjust their parameters for optimum surround effect.
• Then "DRC : ~ " (or "PANO : ~ ") is displayed for several
seconds.
• If the parameter mode disappears, press this button again.
• Then "VS HP" is displayed and the Virtual Surround
Headphone mode is selected.
• To cancel the Virtual Surround Headphone mode, press
the STEREO button.
When adjusting the sound parameters
• The Virtual Surround Headphone mode simulates 5.1 channel surround, which allows you to enjoy 5.1 channel surround
sound through 2 channel hedphones, just like listening from 5.1 channel speakers.
■Note :
• Only when the SPEAKER button is set to off, the Virtual Surround Headphone mode can be selected.
• Select the Virtual Surround Headphone mode.
Listening in Virtual Surround Headphone mode
1. Press the SOUND PARAMETER button.
2. Press the CURSOR UP(▲)/DOWN(▼) buttons to select the desired parameter.
• Each time these buttons are pressed, the parameter mode
changes as follows:
→ "DRC" ↔ "PANO" ↔ "C.WIDTH" ↔ "DIMEN" ←
(Dynamic Range Compression) (Panorama mode) (Center width control) (Dimension control)
• "DRC" can be selected only while playing digital signals
from Dolby Digital or DTS source.
• "PANO", "C.WIDTH" and "DIMEN" can be selected only
while listening in Dolby Pro Logic II Music mode.
■When selecting the "DRC (Dynamic Range Compression :
Night mode)"
This function compresses the dynamic range of previously
specified parts of Dolby Digital or DTS sound track (with extremely
high volume) to minimize the difference in volume between the
specified and non-specified parts. This makes it easy to hear all of
the sound track when watching movies at night at low levels. The
night mode can be set in 11 steps from OFF(0.0) to MAX(1.0)
(default value : OFF(0.0)).
■Note :
• In some Dolby Digital or DTS softwares, the night mode may not
be valid.
3. Press the CURSOR LEFT(◀)/ RIGHT(▶) buttons to adjust the selected parameter as desired.
RD-6504(A)_ENG:RD-6504(A)2009-02-12오 9:03페이지20