Sherwood RD-6106 Stereo Receiver User Manual


  Open as PDF
of 25
 
EENNGGLLIISSHH
16
Adjusting the speaker settings
Press the SPEAKER MODE button for
more than 2 seconds to enter the front-
center-rear speaker mode.
2
Select the desired speaker setting.
3
󳀏 The front-center-rear speaker setting is displayed.
󳀏 When the SPEAKER button is set to off, the 6 CH
DIRECT is selected as an input source or “ANALOG”
is selected as signal input in the stereo mode, the
speaker mode function cannot be available.
󳀏 Adjust the settings of front, center ,rear speakers and
subwoofer connected.
󳀏 If the speaker setting is adjusted to “S”, the low range
bass sound of the channel(s) is redirected to the
subwoofer or the front channels and if the speaker
setting is adjusted to “N”, the sound of the channel(s)
is redirected to other channels.
󳀏 Each time this button is pressed, one of 11 different
speaker settings is selected and displayed for 8
seconds as follows;
FLCSRS, FLCLRS, FLCLRL,
FLCLRN, FLCSRL, FLCNRL,
FLCSRN, FLCNRS, FSCSRS,
FSCSRN and FSCNRS
󳀏 In the displays, F stands for Front, C for Center, R
for Rear, L for Large, S for Small and N for None.
󳀏 When judging whether a speaker is Large or Small,
please note that a standard large speaker has a cone
size larger than 12 cm(5 inches).
󳀏 The following speaker settings cannot be selected.
Front :Small, Center : Large and Rear : Large(FS--
CL--RL) or Center : None and Rear : None(CN--
RN) setting.
SPEAKER
MODE
SPEAKER
MODE
SPEAKER
MODE
Select the desired subwoofer setting.
5
󳀏 The desired speaker setting is memorized and the
receiver enters the subwoofer mode.
󳀏 If the speaker setting display disappears, start again
from step 2 above.
󳀏 Each time this button is pressed, the subwoofer
setting changes and is displayed for 8 seconds as
follows;
SUB W(oofer) -- Y(es): When using a powered
subwoofer.
SUB W(oofer) -- N(o) : When not using a
powered subwoofer.
󳀏 If the front speaker is set to “S”, the subwoofer is
automatically set to “Y”.
MEMO/ENTER
MEMO/ENTER
Memorize the desired speaker setting
while it is displayed.
4
󳀏 If the subwoofer setting display disappears, start
again from step 2 above.
󳀏 Each time this button is pressed briefly, the front-
center-rear speaker or subwoofer setting is
displayed.
Memorize the subwoofer setting while it is
displayed.
6
Checking the speaker setting
SPEAKER
MODE
 previous next