Sharper Image CD Stereo CD Player User Manual


 
Do not use in areas where extremes in temperature occur (below 40°F/5°C or exceeding 95°F/35°C),
or where unit may be exposed to direct sunlight.
Because of the CD player’s extremely low noise and wide dynamic range, there is a tendency to turn
the volume on the amplifier higher than necessary. Doing so may produce an excessively high output
from the amplifier, which can cause damage to the speakers.
Sudden changes in the surrounding temperature can cause dew to form on the optical pickup lens
inside the unit. Under these conditions, the unit may be unable to operate properly. If this should
occur, remove all discs and allow the player to adjust to the surrounding temperature.
Power Supply
AC Power Cord
Plug small end of power cord into power jack marked AC on back of stereo. Insert plug in standard
polarized AC outlet.
Batteries
1. Remove battery panel on back of stereo by pushing down on tab while pulling tab away from
stereo.
2. Insert two AA batteries, being sure to align +/- ends with illustrations inside battery compartment.
(Remote also uses two AA batteries.)
Note:
• Do not mix new batteries with old or used batteries.
* Only use batteries of the same type and brand.
• Remove batteries and store them in a cool place if unit will not be used for an extended period of time.
• Carefully follow the battery manufacturer’s instructions for proper use and disposal.
• Do not allow young children to handle batteries.
• Spent or discharged batteries must be recycled or disposed of properly in compliance with all
applicable laws. For detailed information, contact your local solid waste authority.
SA248