Filter
Top Products
Setting Clock
1. Open CD doors by pressing CD DOOR OPEN/CLOSE.
2. Press CLOCK SET once. Hour number will flash.
3. Use CD-TUNER-SKIP buttons to select the desired hour.
4. Press CLOCK SET again. Minutes number will flash.
5. Use CD-TUNER-SKIP buttons to select the desired minutes.
6. Press CLOCK SET again to set time. Numbers will stop flashing.
Playing CDs
Normal Play
1. Open CD doors by pressing CD DOOR OPEN/CLOSE.
2. Load up to 3 CDs on spindles with information side facing stereo. Discs can be removed by placing
a finger under cutout section next to disc and pulling disc up.
3. Close CD door. Wait a few seconds while unit reads all 3 CDs.
4. Use CD SELECT buttons to choose a CD and press PLAY/PAUSE to play. LCD will show number
of tracks and total recorded time on disc before play begins.
Use CD-TUNER-SKIP buttons to skip to desired track. PLAY/PAUSE temporarily pauses play.
STOP stops CD play.
Programmed Play
1. Load up to 3 discs in stereo.
2. Press CD SELECT buttons or PLAY/PAUSE to read all discs, then press STOP button.
3. Press MEMORY on remote control or Memory Program on stereo. Flashing “MEMORY”
appears on LCD over “00 P-01.”
4. Choose CD with first track to be programmed.
5. Use CD-TUNER-SKIP buttons to select desired track, or press CD SELECT to select another
CD, then choose a track (or tracks) from that CD.
6. Press MEMORY to store selection.
SA248