Filter
Top Products
2012/ October/
17
12_XL-UR14H_OM_EN.fm
E-6
EN
General control (continued)
Press and hold down (X-BASS)/EQ button, the unit will
enter the extra bass mode which emphasises the bass
frequencies and “X-BASS” indicator will light up.
To cancel the extra bass mode, press and hold down
(X-BASS)/EQ button again.
Press (X-BASS)/EQ button, the current mode setting will
be displayed. To change to a different mode, press the (X-
BASS)/EQ button repeatedly until the desired sound
mode appears.
The main unit will enter the stand-by mode after 15
minutes of inactivity during:
CD / USB: In the stop or pause mode.
AUDIO IN: No detection of input signal or very low sound
audibility.
The volume is muted temporarily when pressing the
button on the remote control. Press again to restore the
volume.
When the FUNCTION button is pressed, the current
function will change to different mode. Press the
FUNCTION button repeatedly to select desired function.
Note:
The backup function will protect the memorized function
mode for a few hours should there be a power failure or the
AC power lead becomes disconnected.
Setting the clock (Remote control
only)
In this example, the clock is set for the 24-hour (00:00)
display.
To confirm the time display:
[When the unit is in the stand-by mode]
Press the (TIMER)/CLOCK button. The time display will
appear for about 5 seconds.
[When the power is on]
Press the (TIMER)/CLOCK button. The time display will
appear for about 5 seconds.
Note:
The “00:00” will appear when the AC power supply is
restored after a power failure or unplugging the unit.
Readjust the clock as follows.
To readjust the clock:
Perform “Setting the clock” from step 1.
■ Extra bass Control (X-BASS)
■ Equalizer
■ Auto power off function
■ Muting
■ Function
POPS
VOCAL
FLAT
ROCK
CLASSIC
JAZZ
For rock music.
For pop music.
No equalization.
For classical music.
For jazz.
Vocals are enhanced.
No equalisation.
For rock music.
For classical music.
For pop music.
For jazz.
Vocals are enhanced.
CD USB
FM ST
FM MONOAUDIO IN
1 Press the ON/STAND-BY button to turn to stand-by
mode.
2 Press and hold the (TIMER)/CLOCK button until
“00:00” appear.
3 Within 10 seconds, press the or button to
adjust the hour and then press the MEMORY button.
Press the or button once to advance the time
by 1 hour. Hold it down to advance continuously.
4 Press the or button to adjust the minutes and
then press the MEMORY button. Press the or
button once to advance the time by 1 minute. Hold it
down to advance continuously.