Sharp XL-HF201PH(BK) Stereo System User Manual


 
11/7/8 10_XL-HF201PH_EN.fm
10
9
8
7
6
5
4
3
2
1
E-14
Advanced USB playback
The following functions are the same as CD
operations:
Page
Direct track search. . . . . . . . . . . . . . . . . . . . . . . . . . . .10
Repeat play. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .10
Random play. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .11
Programmed play (MP3/WMA) . . . . . . . . . . . . . . . . . .11
Note:
If USB memory device is not connected, “USB No Media”
will be shown on the display.
Notes:
This unit only supports “MPEG-1 Audio Layer-3”
format. (Sampling Frequency is 32, 44.1, 48kHz)
Playback order for MP3 files may differ depending on
the writing software used during file download.
Bitrate which is supported by MP3 is 32~320 kbps,
WMA is 64~160 kbps.
For MP3/WMA files, please put “.MP3” “.WMA”
extension. Files cannot be played back if there is no
MP3/WMA extension.
Playlists are not supported on this unit.
This unit can display Folder Name or File Name up to
32 characters.
Maximum total number of MP3/WMA files is 65025.
Total number of folders read is 999 including folder with
non-playable file. However, the display shows only
folder with MP3 files.
The display playback time may not be displayed
correctly when playing back a variable bitrate file.
The ID3TAG information supported are TITLE, ARTIST
and ALBUM only. Title name, artist name and album
name can be displayed by pressing the DISPLAY
button during file playback or pause mode.
WMA meta tag also supports title, artist and album
name which are recorded in WMA files. Copyright
protected WMA files cannot be played back.
Listening to the radio
Notes:
When radio interference occurs, auto scan tuning may
stop automatically at that point.
Auto scan tuning will skip weak signal stations.
To stop the auto tuning, press the TUNING ( or )
button again.
When an RDS (Radio Data System) station is tuned in,
the frequency will be displayed first, and then the RDS
indicator will light up. Finally, the station name will
appear.
Full auto tuning can be achieved for RDS stations
“ASPM”, see page 16.
To receive an FM stereo transmission:
Press the TUNER button to select stereo mode and
“ST” indicator will be displayed. “ ” and “ ” will
appear when an FM broadcast is in stereo.
If the FM reception is weak, press the TUNER button to
extinguish the “ST” indicator. The reception changes to
monaural, and the sound becomes clearer.
Tuning
1
Press the ON/STAND-BY button to turn the power on.
2 Press the TUNER button repeatedly to select FM Stereo
or FM Mono.
3 Press the TUNING ( or ) button on the remote
control to tune in to the desired station.
Manual tuning:
Press the TUNING ( or ) button repeatedly to
tune in to the desired station.
Auto tuning:
When the TUNING ( or ) button is pressed for
more than 0.5 seconds, scanning will start
automatically and the tuner will stop at the first
receivable broadcast station.
CD/USB
RDS