Filter
Top Products
11/8/3 01_XLDAB151PH EN_AUS.fm
20
Listening to the DAB+
Digital Audio Broadcasting is a digital transmission system
where audio signals are converted to digital signals for
broadcasting. DAB+ is broadcast as a group of data called
multiplex (ensemble) which may contain one or more
stations (services). Each station contains a primary
service and there may be one or more secondary services.
This allows several programmes or services to be
transmitted on a single frequency.
When turned on for the first time, the unit scans radio
stations automatically to create a station list. You can make
the Auto Scan again when you move the unit to other areas
or add multiplex channels to the station list.
The number of stations found and the scanning process
are shown on the display.
After the scan:
The stations will be stored in alphanumeric order and the
first station on the list will be selected and you will hear it
through the speakers.
● To listen to other stations, see “Selecting a station in
the station list” on page 20.
Notes:
● If no station is found, “No Service” appears.
Once a DAB+ station is received, you can select stations
in the station list.
You can manually store stations which Auto Scan cannot
find. If reception is poor, you can adjust the sensitivity.
Manual tune is only available after Auto Scan. Perform
Auto Scan first.
■ About DAB+ (Digital Audio Broadcasting)
■ Auto Scan
1 Press the TUNER/DAB button until “DAB” appears on
the display.
2 Press DAB SCAN button on the remote control for
more than 3 seconds. Scanning begins.
DAB + SIGNAL
MULTIPLEX
(ENSEMBLE)
SERVICES
SERVICES
COMPONENTS
(STATIONS)
CD/USB
RDS
DAB
+
The number of received
station
The scanning progress
■ Selecting a station in the station list
1 Press the TUNER/DAB button until “DAB” appears
on the display.
2 Whilst receiving a DAB+ station, press the TUNING
( or ) to select the desired station.
3 Within 10 seconds, press the DAB ENTER button on
the remote control to tune into the desired station.
■ Manual tune
1 Press the TUNER/DAB button until “DAB” appears
on the display.
2 Press the DAB SCAN button
once.
3 Within 10 seconds, press the
TUNING ( or ) to select
the DAB+ frequency.
4 Within 10 seconds, press the
DAB ENTER button.
(G: Good, B: Bad)
● Reception sensitivity appears. The percentage
number indicate the current level.
● If the level is too low, move the aerial or unit to
improve reception.
5 Press the DAB ENTER button again to store the
station and exit manual tune.
Display current station
The name of the station
being selected