Filter
Top Products
25
HT-X1
Preparation for Use
" Connecting the AC power cord
After checking all the connections have been made correctly, plug
the AC power cord to the AC power input jack of the subwoofer/
amplifier unit, and then to the AC outlet.
Notes:
! Never use a power cord other than the one supplied. Otherwise,
a malfunction or an accident may occur.
! Unplug the AC power cord from the wall outlet if the subwoofer/
amplifier unit will not be in use for a prolonged period of time.
" To turn the power on
Press the ON/STAND-BY button.
If the power does not turn on, check if the AC power cord and sys-
tem connection cable are plugged in properly.
To set the system to stand-by mode:
Press the ON/STAND-BY button again.
Note:
After the system enters the power stand-by mode, wait a few sec-
onds to turn on again.
Cooling fan:
A cooling fan is built into this subwoofer/amplifier unit for better heat
radiation. Do not cover the opening in this section with any obsta-
cles to avoid damage to the subwoofer/amplifier unit.