Sharp MD-MX30 Stereo System User Manual


 
33
Sleep timer setting
Timer playback (record) setting
Timer playback
(record) start time
30 minutes - 2 hours
Desired time
Sleep operation will
automatically stop.
End time
To confirm the timer setting:
Press the TIMER/DELETE button once.
The turn-on time, the turn-off time will be displayed.
To cancel timer operation:
While in the timer stand-by mode, press the ON/STAND-
BY button to turn the power on.
Press the TIMER/DELETE button repeatedly to turn off
the timer, "f PLAY" or "f REC" will go out.
Caution:
In the following cases, the timer recording function will not
work.
When a MiniDisc has not been inserted.
When a playback-only MiniDisc is inserted.
When the MiniDisc you inserted is protected against acci-
dental erasure.
When there is no recording space left on the MiniDisc you
have inserted (when the "TOC FULL" or "DISC FULL"
message appears).
Sleep operation
The radio, CD and MiniDisc can all be turned off automati-
cally.
1 Play the desired sound source.
2 Press the SLEEP button.
SLEEP
If you do not need to change the time, the unit will enter
the sleep mode automatically.
3 Press the SLEEP button to select the time.
(Maximum: 2 hours - Minimum: 30 minutes)
The amount of sleep time can also be changed during the
sleep operation.
2 hours-30 minutes 30-minute intervals
SLEEP
4 The unit will enter the stand-by mode automatically
after the preset sleep time has elapsed.
To cancel the sleep operation:
Press the SLEEP button repeatedly. "0:00" will appear and
"SLEEP" will go out at the same time.
The sleep operation will be canceled.
To confirm the remaining sleep time:
Press the SLEEP button.
Notes:
Once the sleep time is set, it will remain the same duration
until the setting is changed.
The sleep functions of this unit cannot be used to control
equipment connected to this unit. You must use the sleep
functions of the other equipment, if it has them.
Simultaneous sleep and timer operation
Perform steps 1 - 9 on page 42, "Timer playback/Timer
recording".
Perform steps 1 - 3 of the "Sleep operation" on this page.
(Continued)
SLEEP
ON/
STAND-BY