Filter
Top Products
E-67
SD_HX600_SEC_SECL_E6.fm04/3/15
ENGLISH
TINSKA016AWZZ
SD-HX600
References
- Troubleshooting chart -
Troubleshooting chart
Many potential problems can be resolved by the owner without calling a service tech-
nician.
If something is wrong with this product, check the following before calling your autho-
rized SHARP dealer or service center.
! General
! Tuner
! AV selector
Symptom Possible cause Reference
page
No sound is heard. " Is the volume level set to "0"? P. 20
" Are the headphones connected? P. 65
" Are the speaker wires disconnect-
ed?
P. 15
" Is the correct function selected for
the AV selector?
P. 62
The sounds from speakers
are not well balanced.
" Are the speaker wires connected to
the wrong channels?
P. 15
Noise is heard during play-
back.
" Move the unit away from any com-
puters or mobile phones.
When a button is pressed,
the unit does not respond.
" Set this unit to the power stand-by
mode and then turn it back on. If the
unit still malfunctions, reset it.
P. 69
Interference or noise occurs
on the TV image.
" Is the unit placed near TV with inter-
nal antenna? Use an outdoor anten-
na.
P. 16
Timer playback does not
start.
" Did you remove the plug from the
AC outlet, or did a power failure oc-
cur? Reset the clock and timer.
P. 19, 53
"CLOCK ADJUST" appears
when checking the clock.
" Did you remove the plug from the
AC outlet, or did a power failure oc-
cur? Reset the clock.
P. 19
The display on the unit is
dark.
" Is the display in the dimmer mode? P. 20
The power is not turned on. " Is the unit unplugged? P. 18
No images are displayed. " Is TV turned on? P. 56
" Is the input of TV switched? P. 56
" Is the correct function selected for
the AV selector?
P. 62
Symptom Possible cause Reference
page
The radio makes unusual
noises continuously.
" Is the unit placed near the TV or
computer?
" Is the FM antenna or AM loop anten-
na placed properly? Move the an-
tenna away from the AC power cord
or the unit if located near.
P. 16
The preset channel cannot
be recalled.
" Did you remove the plug from the
AC outlet, or did a power failure oc-
cur?
P. 38
Preset the channel again.
Symptom Possible cause Reference
page
No image appears on a TV,
or images from the source
equipment do not appear.
" Is the same function selected for the
main unit and AV selector?
P. 22, 62
Image cannot be played
back. (Sound is not heard.)
" Is the same function selected for the
main unit and AV selector?
P. 62
" Are the video and audio cables con-
nected improperly?
P. 13, 61
" Is the AV selector turned on? P. 18
After recording, contents are
not recorded on DVD-R,
DVD-RW discs or video-
tapes.
" Are the source equipment and target
equipment connected properly?
P. 61, 63
" Is the same function selected for the
main unit and AV selector?
P. 62 - 64
" Is the correct channel selected for
the target equipment?
P. 63
" Are you recording material with copy
protection?
P. 62 - 64
" Is the source equipment connected
with a component video cable?
P. 64
" Is the source equipment connected
with a digital audio cable?
P. 64