Sharp MD-MX30 MD Stereo System User Manual


 
19
Tuning
1 Press the ON/STAND-BY button to turn the power on.
2 Press the TUNER (BAND) button.
3 Press the TUNER (BAND) button to select the desired
frequency band (FM ST, FM or AM).
FM ST
FM
AM
4 Press the TUNING (
XX
XX
X or
WW
WW
W) button to tune into the
desired station.
Manual tuning:
Press the TUNING (X or W) button as many times as re-
quired to adjust the frequency shown on the display to the
frequency of the desired station.
Auto tuning:
When the TUNING (X or W) button is pressed for more than
0.5 seconds, scanning will start automatically and the tuner
will stop at the first receivable broadcast station.
When radio interference occurs during auto scan tuning,
auto scan tuning may stop automatically at that point.
If a weak station signal is found during auto scan tuning,
the station will be skipped.
To stop the auto tuning, press the TUNING (X or W) but-
ton again.
5 To receive an FM stereo transmission, press the
TUNER (BAND) button so that the "ST" indicator on
the display lights up.
ST
"j" will appear when an FM broadcast is in stereo.
If the FM reception is weak, press the TUNER (BAND)
button so that the "ST" indicator goes out.
The reception changes to monaural, the sound becomes
clearer.
After use:
Press the ON/STAND-BY button to enter the stand-by mode.
Notes:
The last station tuned in will be recalled, even after chang-
ing the tuning band or the function, or after switching the
unit to the stand-by mode.
If the unit's tuner interferes with the reception of a nearby
TV or radio, move the unit as far away from these items as
possible.
RADIO OPERATION
1
4
2,3,5
1
2,3,5