Filter
Top Products
04/1/28 DKCL6N_EN
7
System connections (continued)
Notes:
●
Backup battery system to provide continuous alarm operation
and clock setting in event of a power failure. If the battery low
indicator display is flashing, replace the backup batteries.
Please make sure the AC adaptor is connected, otherwise all
setting may be lost during battery replacement.
● Remove the batteries if the unit will not be used for a long period
of time to prevent battery leakage which may cause potential
damage.
Battery life:
Note:
Battery life may vary depending on the temperature, battery types
and usage conditions.
Precautions for battery use:
● Installing the batteries incorrectly may cause the unit to
malfunction.
● Insert the batteries according to the direction indicated in the
battery compartment.
● Replace all old batteries with new ones at the same time.
● Do not mix old and new batteries.
● Batteries (battery pack or batteries installed) shall not be
exposed to excessive heat such as sunshine, fire or the like.
Caution:
Do not use rechargeable batteries (nickeI-cadmium battery, etc.).
Remote control (For DK-CL6N only)
This product contains a CR Coin Lithium Battery which contains
Perchlorate Material – special handling may apply. California
residents, see www
.dtsc.ca.gov/hazardouswaste/perchlorate/
Precautions for battery use:
●
Remove the battery if the unit will not be used for a long period
of time. This will prevent potential damage due to battery
leakage.
Caution:
● Do not use rechargeable battery (nickel-cadmium battery, etc.).
● Danger of explosion if battery is incorrectly replaced.
● Replace only with the same or equivalent type.
● Batteries (battery pack or battery installed) shall not be exposed
to excessive heat such as sunshine, fire or the like.
● Installing the battery incorrectly may cause the unit to
malfunction.
Notes concerning use:
● Replace the battery if the operating distance is reduced or if the
operation becomes erratic. Purchase “CR 2032” 3 V, coin lithium
battery.
● Periodically clean the transmitter on the remote control and the
sensor on the unit with a soft cloth.
● Exposing the sensor on the unit to strong light may interfere with
operation. Change the lighting or the direction of the unit if this
occurs.
●
Keep the remote control away from moisture, heat, shock, and
vibrations.
Check the remote control after checking all the connections (see
pages 6 - 7).
Point the remote control directly at the remote sensor on the unit.
The remote control can be used within the range shown below:
Press the ON/STAND-BY button. Does the power turn on? Now, you
can enjoy the music.
■
Install/Replace backup batteries
Use 2 “AA” size batteries (UM/SUM-3, R6, HP-7 or similar).
Batteries are not included.
1
Open the battery cover.
Slide the cover in the direction of the arrow.
2
Insert the batteries according to the direction indicated in
the battery compartment.
3
Close the cover.
Battery type
ALKALINE (AA) (1.5V)
Usage time
Approx. P hrs.
■
Battery installation
1
Open the battery cover.
Slide the cover in the direction of the arrow.
2
Insert the battery according to the direction indicated in the
battery compartment.
Back of remote control
Positive (+)
side up
■
Test of the remote control
SLEEPSLEEP
MENUMENU ENTERENTER
BANDBAND
RADIORADIO
iPodiPod
AUX -TV OUT
AUX -TV OUT
EQUALIZEREQUALIZER
PROG-PROG
Remote sensor
15˚
15˚
8" - 20'
(0.2m - 6m)