Sharp DKCL6N Headphones User Manual


 
04/1/28 DKCL6N_EN
3
IMPORTANT SAFETY INSTRUCTIONS (continued)
17) Object and Liquid Entry - Never push objects of any kind into this
product through openings as they may touch dangerous voltage
points or short-out parts that could result in a fire or electric
shock. Never spill liquid of any kind on the product.
18 Damage Requiring Service - Unplug this product from the wall
outlet and refer servicing to qualified service personnel under the
following conditions:
a) When the AC cord or plug is damaged,
b) If liquid has been spilled, or objects have fallen into the
product,
c) If the product has been exposed to rain or water,
d) If the product does not operate normally by following the
operating instructions. Adjust only those controls that are
covered by the operating instructions as an improper
adjustment of other controls may result in damage and will
often require extensive work by a qualified technician to
restore the product to its normal operation,
e) If the product has been dropped or damaged in any way,
and
f ) When the product exhibits a distinct change in
performance - this indicates a need for service.
19)Replacement Parts - When replacement parts are required, be
sure the service technician has used replacement parts
specified by the manufacturer or have the same characteristics
as the original part. Unauthorized substitutions may result in fire,
electric shock, or other hazards.
20)Safety Check - Upon completion of any service or repairs to this
product, ask the service technician to perform safety checks to
determine that the product is in proper operating condition.
21)Wall or ceiling mounting - When mounting the product on a wall
or ceiling, be sure to install the product according to the method
recommended by the manufacturer.
22)Power Lines - An outside antenna system should not be located
in the vicinity of overhead power lines or other electric light or
power circuits, or where it can fall into such power lines or
circuits. When installing an outside antenna system, extreme
care should be taken to keep from touching such power lines or
circuits as contact with them might be fatal.
23)Outdoor Antenna Grounding - If an outside antenna or cable
system is connected to the product, be sure the antenna or cable
system is grounded so as to provide some protection against
voltage surges and built-up static charges. Article810 of the
National Electrical Code, ANSI/NFPA 70, provides information
with regards to proper grounding of the mast and supporting
structure, grounding of the lead-in wire to an antenna discharge
unit, connection to grounding electrodes, and requirements for
the grounding electrode.
24)Protective Attachment Plug - The product is equipped with an
attachment plug having overload protection. This is a safety
feature. See Instruction Manual for replacement or resetting of
protective device. If replacement of the plug is required, be sure
the service technician has used a replacement plug specified by
the manufacturer that has the same overload protection as the
original plug.
25)Stand - Do not place the product on an unstable cart, stand,
tripod or table. Placing the product on an unstable base can
cause the product to fall, resulting in serious personal injuries as
well as damage to the product. Use only a cart, stand, tripod,
bracket or table recommended by the manufacturer or sold with
the product. When mounting the product on a wall, be sure to
follow the manufacturer's instructions. Use only the mounting
hardware recommended by the manufacturer.
SPECIAL NOTES
Page
General Information
Precautions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Controls and indicators . . . . . . . . . . . . . . . . . . . . . . 4 - 5
Preparation for Use
System connections . . . . . . . . . . . . . . . . . . . . . . . . . 6 - 7
Installing the security cable (For DK-CL66N only) . . . . . 6
Remote control (For DK-CL6N only). . . . . . . . . . . . . . . . 7
Basic Operation
General control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Setting the clock and day . . . . . . . . . . . . . . . . . . . . . . . . 8
iPod
Listening to the iPod . . . . . . . . . . . . . . . . . . . . . . . . 9 - 10
Page
Radio
Listening to the radio . . . . . . . . . . . . . . . . . . . . . . .10 - 11
Advanced Features
Alarm and sleep operation. . . . . . . . . . . . . . . . . . 11 - 12
Enhancing your system . . . . . . . . . . . . . . . . . . . . . . . . 13
References
Troubleshooting chart . . . . . . . . . . . . . . . . . . . . . .13 - 14
Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
CONSUMER LIMITED WARRANTY . . . . . . .Back cover
ANTENNA LEAD INWIRE
POWER SERVICE GROUNDING
ELECTRODE SYSTEM
(NEC ART 250, PART H)
GROUNDING CONDUCTORS
(NEC SECTION 810-21)
GROUND CLAMPS
NEC - NATIONALELECTRICAL CODE
S2898A
ELECTRIC
SERVICE
EQUIPMENT
GROUND
CLAMP
Example of antenna grounding as per
National Electrical Code, ANSI/NFPA 70
ANTENNA DISCHARGE UNIT
(NEC SECTION 810-20)
Products that have earned the
ENERGY STAR
®
are designed
to protect the environment
through superior energy
efficiency.
ENERGY STAR
®
Program Information
ENERGY STAR
®
is a U.S. registered mark.
CONTENTS