Filter
Top Products
03/12/17 CD-SW200 _2-14.fm
13
CD-SW200
Preparation for Use
Placing the speaker system
The left and right speakers have individual shapes. For best perfor-
mance, place the speakers according to the diagram below.
Note:
The speaker grilles are not removable.
AC power connection
After checking all the connections have been made correctly, plug
the AC power cord of this unit into the AC outlet. If you plug in the unit
first, the unit will enter the demonstration mode.
Notes:
The unit will start the tape initialization when plugged in to the AC
outlet. During this process, initializing sound will be heard and the
unit cannot be turned on. Wait until the process is finished.
Unplug the AC power cord from the AC outlet if the unit will not be
in use for a prolonged period of time.
Demonstration mode
Outdoor FM antenna
Use an outdoor FM antenna if you require better reception.
Consult your dealer.
Cooling fan:
The main unit is built with a cooling fan at the rear of the unit for im-
proved cooling. Please do not cover the opening of the fan with any
obstacles, as this will block proper ventilation.
Table
Floor
Left speaker Main unit Right speaker
Subwoofer
AC outlet
(AC 120 V, 60 Hz)
The first time the unit is plugged in, the
unit will enter the demonstration mode.
You will see words scroll and the sub-
woofer will light up in flashing mode.
To cancel the demonstration mode:
When the unit is in the power stand-
by mode (demonstration mode),
press the X-BASS (SURROUND)/
DEMO button. The unit will enter the
low power consumption mode and
the subwoofer light up will be off.
To return to the demonstration mode:
When the unit is in the power stand-by mode, press the X-BASS
(SURROUND)/DEMO button again.
Note:
When the power is on, the X-BASS (SURROUND)/DEMO button can
be used to select the extra bass mode.
Note:
When an outdoor FM antenna is used, disconnect the supplied FM
antenna wire.
Outdoor FM antenna
75 ohms
coaxial cable