Filter
Top Products
03/12/17 CD-SW200 _2-14.fm
12
CD-SW200
Preparation for Use
System connections (continued)
Antenna connection
Supplied FM antenna:
Connect the FM antenna wire to the FM 75 OHMS terminal and po-
sition the FM antenna wire in the direction where the strongest signal
can be received.
Supplied AM loop antenna:
Connect the AM loop antenna to the AM LOOP jack. Position the AM
loop antenna for optimum reception. Place the AM loop antenna on
a shelf, etc., or attach it to a stand or a wall with screws (not sup-
plied).
Note:
Placing the antenna on the unit or near the AC power cord may
cause noise pickup. Place the antenna away from the unit for better
reception.
Installing the AM loop antenna:
Speaker connection
FRONT SPEAKERS:
Connect the black wire to the FRONT SPEAKERS minus (-) terminal,
and the red wire to the FRONT SPEAKERS plus (+) terminal.
SUBWOOFER:
1. Connect the black wire to the SUBWOOFER minus (-) terminal,
and the red wire with purple insulation tube to the SUBWOOFER
plus (+) terminal.
2. Connect the subwoofer light-up wire to the SUBWOOFER
LIGHT-UP jack.
Caution:
< Assembling > < Attaching to the wall >
Wall Screws (not supplied)
ANTENNA
AM
LOOP
FM
75 OHMS
GND
Never mistake the FRONT SPEAKERS and the SUBWOOFER
terminals. The unit or the speakers may be damaged.
If you use other speakers with an impedance lower than that
specified, the unit may be damaged. Front speakers: 6 ohms,
Subwoofer: 12 ohms.
Do not mistake the right and the left
channels. The right speaker is the one on the
right side when you face the unit.
Do not let the bare speaker wires touch
each other.
Do not stand or sit on the speakers. You may
be injured.
Do not allow any objects to fall into or to be
placed in the bass reflex duct.
Incorrect
Black
Red
Red
Black
SUBWOOFER