Filter
Top Products
03/12/19 CD-MPS660E(A)3.fm
35
CD-MPS660E
TINSZA040AWZZ
References
! Headphones
"
Before plugging in or unplugging the headphones, reduce the
volume.
"
Be sure your headphones have a 3.5 mm (1/8") diameter plug
and are between 16 ohms and 50 ohms impedance. The recom-
mended impedance is 32 ohms.
"
Plugging in the headphones disconnects the speakers automati-
cally. Adjust the volume using the VOLUME control.
Troubleshooting chart
Many potential problems can be resolved by the owner without call-
ing a service technician.
If something is wrong with this product, check the following before
calling your authorised SHARP dealer or service centre.
! General
! CD player
Symptom Possible cause
"
The clock is not set to the
correct time.
"
Did a power failure occur? Reset
the clock. (Refer to page 13.)
"
When a button is pressed,
the unit does not respond.
"
Set the unit to the power stand-
by mode and then turn it back on.
"
If the unit still malfunctions, reset
it. (Refer to page 36.)
"
No sound is heard.
"
Is the volume level set to "0"?
"
Are the headphones connected?
"
Are the speaker wires discon-
nected?
Symptom Possible cause
"
Playback does not start.
"
Is the disc loaded upside down?
"
Playback stops in the mid-
dle or is not performed
properly.
"
Does the disc satisfy the stan-
dards?
"
Is the disc distorted or
scratched?
"
Playback sounds are
skipped, or stopped in the
middle of a track.
"
Is the unit located near excessive
vibrations?
"
Is the disc very dirty?
"
Has condensation formed inside
the unit?
8