Filter
Top Products
22
CD-DP900E(UK)_2.fm02/1/8
CD-DP900E
Tape Recording
- Recording to a cassette tape -
Recording to a cassette tape
Before recording:
When recording important selections, make a preliminary test to ensure that the
desired material is properly recorded.
SHARP is not liable for damage or loss of your recording arising from malfunction
of this unit.
The volume and sound controls can be adjusted with no effect on the recorded
signal (Variable Sound Monitor).
For recording, use only normal tapes. Do not use metal or CrO tapes.
Recording can be operated in the TAPE 2 compartment. The TAPE 1 is for playback only.
Recording from a CD (CDs)
You can record 3 CDs continuously.
To perform programmed recording:
To stop recording:
Press the (CD ) button.
The CD and tape will stop.
Notes:
When the end of the tape is reached whilst recording, the CD player will display
the track number which was being played at that time, and stop automatically. If
you want to restart recording from the beginning of the interrupted track, turn over
the tape, press the REC PAUSE ( ) button and then the / (TAPE 2 ) but-
ton. (If tracks have been stored in memory by programming, recording will restart
from the first track stored in memory.)
Whilst recording, OPEN/CLOSE button is deactivated. It is recommended to
perform CD recording after closing the disc tray.
1
Press the ON/STAND-BY button to turn the power on.
2
Load a cassette into the TAPE 2 cassette compartment with the
side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be performed.
3
Press the CD button and load the desired disc.
4
Press the DISC SKIP button to select the disc to be recorded first.
5
Press the REC PAUSE ( ) button.
Recording will be paused.
6
Press the / (TAPE 2 ) button to start recording.
CD playback will start approximately 7 seconds after the tape starts.
Recording is started from the selected CD. When the playback of the last disc
is finished or the end of the tape is reached, the CD and the cassette will stop
automatically.
1 Programme discs and tracks. (See page 18.)
2 Press the REC PAUSE ( ) button.
3 Press the / (TAPE 2 ) button.
Programmed play (See page 18.)