Filter
Top Products
<P=002>
2,3,5,6
1
4
RADIO OPERATION
■ Tuning
1 Press the ON/STAND-BY button to turn the power on.
2 Press the TUNER (BAND) button.
3 Press the TUNER (BAND) button to select the desired fre-
quency band. (FM ST, FM or AM)
4 Press the TUNING/TIME ( or ) button to tune into the
desired station.
Manual tuning:
Press the TUNING/TIME ( or ) button as many times as
required to adjust the frequency shown on the display to the
frequency of the desired station.
Auto tuning:
When the TUNING/TIME ( or ) button is pressed for more
than 0.5 seconds, scanning will start automatically and the tuner
will stop at the first receivable broadcast station.
Notes:
● When radio interference occurs during auto scan tuning, auto
scan tuning may stop automatically at that point.
● If a weak station signal is found during auto scan tuning, the
station will be skipped.
● To stop the auto tuning, press the TUNING/TIME ( or )
button again.
5 To receive an FM stereo transmission, press the TUNER
(BAND) button so that the "ST" indicator on the display lights
up.
● " " will appear when an FM broadcast is in stereo.
6 If the FM reception is weak, press the TUNER (BAND) button
so that the "ST" indicator goes out.
● The reception changes to monaural, and the sound becomes
clearer.
After use:
Press the ON/STAND-BY button to enter the stand-by mode.
Note:
● The last station tuned in will be recalled, even after changing
the tuning band or the function, or after switching the unit to
the stand-by mode.
MEMORY/
SET
PRESET( )
■ Preset tuning
You can store up to 40 stations in memory (40 stations consisting
of any combination of FM and AM stations you like) and recall
them at the push of a button.
To enter stations into memory:
1 Perform steps 1 - 6 in the "Tuning" section.
2 Press the MEMORY/SET button.
● "MEMORY" and the preset channel number will flash.
3 Within 30 seconds, press the PRESET ( or ) button to
make the preset channel number flash in the display.
● Store the stations in memory, in order, starting with preset
channel 1.
4 Within 30 seconds, press the MEMORY/SET button to store
that station in the selected station preset number memory.
● If the "MEMORY" and preset number indicators go out before
the station is memorized, repeat the operation from step 2.
5 Repeat steps 1 - 4 to set other preset stations, or to change
a preset station.
● When a new station is stored in the selected station preset
number memory, the contents previously memorized will be
erased.
(Main unit operation)
(Main unit operation)
CD-BA200(SEC) TINSE0276AWZZ
11