Filter
Top Products
6
Replacing the wind screen
If the wind screen shows signs of wear such as tears or
holes, replace the wind screen.
J Pull the wind screen from the microphone. Gently slide-
on the new wind screen and ensure that it fits securely
over the microphone.
Storage and transportation
K Turn the microphone into the position shown on the
diagram. Rotate the earcups by 90°.
Use the supplied carrying bag for storage and
transportation.
If problems occur ...
Problem Possible cause Possible solution
You cannot
communicate
via the
intercom.
The microphone
connection has been
pulled out.
Check if the microphone
jack plug is connected
correctly.
The microphone
sensitivity is
adjusted too low.
Increase the microphone
sensitivity (see “Adjusting
the microphone
sensitivity” on page 4).
HME43-K_515687_1107.book Seite 6 Mittwoch, 20. Februar 2008 10:23 10