Filter
Top Products
21
Using the receiver
̈ Position the transmitter’s infra-red interface at a max. distance of 5 cm
in front of the infra-red interface (sync) A.
The transfer starts automatically. During the transfer, the two blue
LEDs in the infra-red interface (sync) A flash and the backlighting of
the sync button 9 flashes green.
– After successful completion of the synchronization, the two blue
LEDs in the infra-red interface (sync) A stop flashing and the
sync button 9 is backlit in green. The receiver’s frequency and name
are now also set on the transmitter and the transmission link is ready
for operation.
– If an error occurred during synchronization (e.g. the transmitter is
too far away from the receiver), the two blue LEDs in the infra-red
interface (sync) A stop flashing and the sync button 9 is backlit in
red.
Identifying receivers using the “Wireless Systems
Manager” software (identifying function)
In multi-channel operation, it can be useful to identify the individual chan-
nels of the receivers via the “Wireless Systems Manager” software. The
identifying function shows you which channel is assigned to which
receiver.
̈ Start the identifying function as described in the instruction manual of
the “Wireless Systems Manger” software.
“Identified” appears on the status display of the identified receiver:
After 60 seconds, the text disappears and the current status display is
shown again.
To change to the current status display before the end of the 60 seconds:
̈ Press the esc button 6.
esc
save
sync
digital audio
processing
sync
5cm
<
300
100
30
10
1
5
10
PEA
µV
RF
%
A B
SKM 5200-II
The infra-red interface of the SKM 5200-II hand-held transmitter is
located at the left-hand margin of the display. Position the trans-
mitter’s infra-red interface precisely in front of the receiver’s infra-
red interface (sync) A.
Identified
esc
save
clock
sync
M
H
z
6.000
.01
BANK
CH
6
COM
AF
HD
P