Wireless RS 65-9
English
Charging the accupack
For charging the accupack, place the headphones
into the transmitter’s charging compartment (nb:
make sure the headphones are inserted the
correct way round. The Sennheiser logo on the
headband must be readable looking from the
front - see diagram. The charging contacts are on
the RH earpiece of the headphones - these are
placed on the corresponding contacts in the LH
indentation of the transmitter, the one next to
the “charge” light). The red LED on the transmitter must light up to show charging is
taking place.
Always store the headphones on the transmitter to ensure that they are fully charged
when they are needed. The headphones are automatically switched off by the
charging process.
BA 151 spare accupack
When the headphones’ accupack is going flat (noise, interference and distortion are
sure signs of a flat accupack), recharge the accupack. After an initial charging of 24
hours, the normal charging time is 14 hours. A fully charged accupack has an
operating time of more than four hours. Place the discharged accupack in the
charging compartment at the back of the transmitter and use the spare accupack in
the meantime.
Additional BA 151 spare accupacks can be charged via the L 151-2 charger (available
from your specialist dealer).
Before disposing of an old and exhausted accupack, make sure that it is totally
discharged by using it until the device switches off. To protect the environment, only
dispose of totally exhausted accupacks.
Sound Retrieval System (SRS)
This device is equipped with SRS, a system that creates a full bodied three
dimensional sound image from a stereo signal. You can switch SRS
ON and OFF by
pressing the S
URROUND button on the transmitter.
Additional information
The audio transmission technology used with this device is basically that of a radio.
According to today’s scientific knowledge, the radio waves emitted by this device are
not harmful to humans or animals.
ATTENTION: LISTENING AT HIGH VOLUME LEVELS FOR LONG
PERIODS CAN PERMANENTLY DAMAGE YOUR HEARING.
This device has been designed for use with stereo devices. For connection to
mono devices, please use a stereo to mono jack plug available from most audio
accessory shops.
Use a soft cloth or, if necessary, a damp wash-leather for cleaning the devices. Do not
use aggressive cleansing agents.
is a trademark of SRS Labs, Inc.
RS65.book Seite 9 Dienstag, 18. Mai 2004 2:09 14