Filter
Top Products
2
Inserting/replacing the battery
If the battery voltage is sufficient, the “batt” LED » flashes briefly when you
switch on the microphone. A new, unused battery has an operating time of
approx. 300 hours.
When the battery voltage decreases, the “batt” LED » lights up
permanently. You should replace the battery. When the “batt” LED » lights
up permanently for the first time, the remaining operating time is approx. 50
hours.
Note: When not using the microphone for extended periods of time,
remove the battery from the battery compartment!
To insert or replace the battery:
̈ Push the catch of the battery compartment ¶ in
the direction of the flashmount adapter and open
the battery compartment.
̈ Insert the AAA size battery as shown in the
diagram on the right. Observe correct polarity
when inserting the battery.
̈ Close the battery compartment until the catch ¶
locks into place.
Puting the microphone into operation
̈ Slide the microphone onto the video camera’s flashmount and lock the
microphone by screwing down the knurled washer ².
̈ Insert the 3.5 mm stereo jack plug into the microphone input socket of the
video camera.
MKE400_516599_0607_SP6.book Seite 2 Freitag, 2. November 2007 12:16 12