Filter
Top Products
Remote Control Battery Installation
The remote control transmitter is designed to operate with two (2) “AA” size batteries (not included). To
install the batteries, slide the battery compartment cover open on the back of the remote control (see figure
4) and insert two (2) “AA” size batteries observing the polarity indicated in the compartment. Replace the
battery compartment cover.
AUX IN
You can connect an external audio device, such as a cassette deck, TV, VCR, satellite, video game, etc.,
into these jacks. Simply connect the left and right cables of the external device into the Left and Right AUX
IN jacks on the rear of the unit. When using the unit connected to the AUX IN jacks, press the AUX Function
button on the main unit.
LINE OUT
You can connect an external recording device, such as a cassette recorder, into these jacks. Simply connect
the left and right cables of the external recording device into the Left and Right LINE OUT jacks on the rear
of the unit.
DIGITAL OUT
NOTE: Remove the plug from the DIGITAL OUT jack before using.
You can connect an external DIGITAL recording device, such as a minidisc or CD recorder, into this jack.
Simply connect the optical cable (not included) of the external digital recording source into the DIGITAL OUT
jack on the rear of the unit.
HEADPHONE JACK
Connect a pair of stereo headphones (not included) to this jack for private listening without disturbing others.
The speakers are shut off when headphones are connected to the headphone jack.
3
BATTERY PRECAUTIONS
Follow these precautions when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Reversed
batteries may cause damage to the device.
3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh ones.
4. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from
possible battery leakage.
5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture.
(Follow battery manufacturer’s directions.)
–
+
–
+
Figure 4
SMV300 O/M.QXD 6/21/01 7:46 AM Page 3