Filter
Top Products
9
FUNCTION SELECT
Touch FUNC on the unit or press the FUNCTION button on the remote control to change the mode of each function.
Display changes as below:
AUX
CD
TUNER
USB IPODCARD
RADIO OPERATION
Touch FUNC on the unit or press the FUNCTION button on remote control to select TUNER.
1. Touch BAND on the unit or press the BAND button on remote control to select AM or FM.
2. Touch or on the unit or press the or button on the remote control to tune the desired station.
Manual Tuning
To tune for weak stations, use manual tuning by touching the or continuously until you read the correct
frequency or the reception is at its best.
Automatic Tuning
1. Touch or on the unit or press the or button on the remote control for a second or more, then
release the button. The tuner will automatically search the first station of sufficient signal strength.
2. Repeat above procedure if you wish to select another station.
Mono/stereo select
You can select the MONO/STEREO only in FM mode.
1. When you want to select FM stereo station, press the ID3/MONO/STEREO button .
When you receive a FM stereo station the " " indicator will appear on the display, you can receive FM stereo
transmission .
2. When you press the ID3/MONO/STEREO button again, the FM STEREO indicator will turn off and switch to MONO
FM status.
Programming preset stations
You can also preset stations of your choice and store up to10 AM and 30 FM stations in its memory. To store your
selected broadcasting stations:
1. Touch BAND on the unit to toggle between AM and FM to make your selection.
2. Tune to the desired station.
3. Press the iPod/MEM/C-ADJ. Button.
4. Press the PRESET/FOLDER ▲ or ▼ button for your desired station number.
5. Press the iPod/MEM/C-ADJ. button again to confirm your selection.
6. To program more stations into memory, repeat the above steps 2 to 5.
7. To change the stored preset stations, repeat the above steps 2 to 5.
Note: Storing a new station into a preset location will erase the previously stored station in that location.
Selecting the Preset Stations
1. Touch BAND on the unit or press the BAND button on the remote control to select the desired band.
2. Press the PRESET/FOLDER ▲ or ▼ button to select the desired preset station number.
3. The location number of preset station is displayed along with the corresponding requency.
FM Antenna
For better FM reception, change the position of FM antenna wire.
AM external aerial loop operation
Adjust the position of AM external aerial loop for better AM frequency signal.