Filter
Top Products
54
POWER SUPPLY
Plug one end of the AC adapter into the
DC 4.5V jack, then plug the other end
into an AC wall outlet.
ALKALINE BATTERY INSTALLATION
Insert two AA batteries (not supplied) into
the battery compartment on the bottom of
the unit. Be sure to observe the proper
polarity (the"+" and" - " signs) as
indicatedinsidethebatterycompartment.
NOTE ON ALKALINE BATTERIES
REMEMBER
Ê
Ë
Ì
Ê
Ë
When replacing the alkaline batteries,
use two new batteries of the same
type. Do notmix a usedbattery with a
new one or mix different types of
batteries.
When inserting the batteries,
mistakenly inserting even one with
improperpolaritywillcauseleakage.
Never charge, heat, disassemble, or
throwbatteriesintoafire.
If the symbol " " flashes in the
display, your batteries are weak.
Replace themor use theAC adapter
If the display is blank no numbers
showwhen PLAY/PAUSEbutton is
pushed, the batteries are dead.
Replace them, or use AC adapter.
(Also check if you inserted the
batteries according to the + and - as
or
cigarettelighter adapter(CDP-244CRB
only).
i
The supplied cigarette lighter adapter is designed for use with vehicles that have a
12V, negative ground electrical system.
Most vehicles have this type of electrical system, but if you are unsure about the
system in your vehicle, contact the vehicle dealer.
i
Precautions on using the AC Adapter.
Ê
Ë
Do not touch the AC adapter with wet
hands. Doing so is dangerous, as this
could result in an electrical shock.
If the AC adapter is connected when
the batteries are installed, the power
supply automatically switches to the
AC power source and the batteries are
disconnected.
IMPORTANT NOTE:
Spent or discharged batteries must be
recycled or disposed of properly in
compliance with all applicable laws. For
detailed information, contact your local
solidwasteauthority.
CIGARETTE LIGHTER ADAPTER (FOR
CDP-244CRB)
Plug one end of the cigarette lighter
adapter into the [DC IN 4.5V], then plug
the other end into the cigarette lighter
jack.
Caution on the cigarette lighter adapter.
i
i
i
i
Use this unit only with the supplied
cigarette lighter adapter. Use with
other cigarette lighter adapters could
damage the unit.
When the inside of the cigarette
lighter jack is dirty with ashes or
dust, the plug section may become
hot due to poor contact. Be sure to
clean the cigarette lighter jack before
use.
After use, disconnect the cigarette
lighter adapter plugs from both this
unit and the cigarette lighter jack.
The cigarette lighter adapter may
cause interference with reception
from the car radio or another radio
inside the vehicle. If this is the case,
disconnect the cigarette lighter
adapter from the cigarette lighter
jack, or use the radio at a distance
from the cigarette lighter adapter.
DC IN 4.5V
CAR KIT ADAPTER (FOR CDP-244CR ONLY)