Filter
Top Products
SETUP
42
To increase Effect level
Adjusting DSP Sound Parameters
You can fine-adjust DSP modes more minutely by changing
three parameters—room, liveness, and reverberation.
To increase Effect level
•
The effect level can be set in steps from 1 to 4 EFFECT1 ➔
EFFECT2 ➔ EFFECT3 ➔ OFF(DEFAULT).
Each time the button is pressed the selection moves to the next
effect.
•
The higher the number, the stronger the DSP surround effect will be.
Effect
Press the DSP/DPL II Effect button.
What is a Effect?
This sets the strength of
the DSP mode.
•
This function works only in the DSP Mode.
•
This function works only in the DSP Mode.
23
Press the Sound Edit button.
•
Each time you press the button, the
indication on the display changes as follows:
1
Press the DSP/DPL II Mode button.
Press the Left/Right ( / ) button to
adjust the DSP sound parameter.
▲
▲
ROOM :
To adjust the resonance based on the room size.
The larger this value is, the more effective the
resonance is (from 04 to 16 by 2 steps).
LIVE (Liveness) : To adjust the liveness. The larger this
value is, the more liveness is obtained
(from 04 to 16 by 2 steps).
REVERB (Reverberation)
: To adjust the reverberation time
of the sound (from 0.0 msec to
1.6 msec by 0.2 msec steps).
00 F 00
00 R 00 REAR SW
Normal
indication
(canceled)
REVERB
LIVE ROOM