Filter
Top Products
•
F.L (Front-Left) : -10 ~ +10dB
•
CEN (Center) : -10 ~ +10dB
•
F.R (Front-Right) : -10 ~ +10dB
•
S.R (Surround-Right) : -10 ~ +10dB
•
S.L (Surround-Left): -10 ~ +10dB
•
S.W (Subwoofer): -10 ~ +10dB
26
Test Tone Output
Press SETUP button.
•
“SETUP MODE” appears on the display and enters into Setup Mode.
Press INPUT button 5 times.
•
“TEST-T MANU” appears in the display.
Press SURROUND button.
•
Each time you press this button, F.L ➝ CEN ➝F.R ➝ S.R ➝ S.L ➝S.W will be
selected in turn.
Press SELECT( )button to set the test tone as you want.
•
You can adjust the speaker output level from -10 to +10dB by 1 step.
√
To Manually Output Test Tone
MAIN UNIT
1
2
4
3
To Stop Test Tone
Method 1) Press INPUT button 1 time.
•
“TEST-T OFF” appears on the display and test signal stops.
Method 2) Turn VOLUME CONTROL.
•
“SETUP MODE OFF” appears on the display and test tone stops.
,
OPERATION
25
Test Tone
Use test tone to check speaker connection status or level.
Press SETUP button.
•
“SETUP MODE” appears on the display and enters into Setup Mode.
Press INPUT button 4 times.
•
“TEST-T AUTO” appears in the display.
Press SURROUND button.
•
Test signal will be automatically output as follows; F.L ➝ CEN ➝F.R ➝
S.R ➝ S.L ➝S.W .
•
During test signal output, press SELECT ( ) button to adjust the speaker
output level from -10 to +10 dB by 1 step.
√
To Automatically Output Test Tone
MAIN UNIT
1
2
3
To Stop Test Tone
Method 1) Press INPUT button 2 times.
•
“TEST-T OFF” appears on the display and test tone stops.
Method 2) Turn VOLUME CONTROL.
•
“SETUP MODE OFF” appears on the display and test tone stops.
,