Filter
Top Products
45 46
Listening to a Cassette
Always treat your cassettes with care; refer, if necessary, to the section entitled
“Precautions When Using Audio Cassettes” on page 56.
REPEAT A↔B Function
•
Use this to listen to a specific section again during playback.
•
Set the start and end points of the section you want to repeat 3 times.
•
This is a useful when learning a foreign language.
•
The TAPE REPEAT function can be used only on sections that are longer
than 7 seconds.
Press REP. A↔B button.
Selecting the Cassette Playback Mode
Your micro component system has three cassette playback modes which enable
you to listen to both sides of a cassette automatically.
Press REV.MODE until the appropriate symbol is
displayed.
•
: One side of the selected cassette and then stops.
•
: One side of the cassette.
The other side of the cassette and then stops.
•
: Both sides of the cassette indefinitely until you press stop.
•
Insert a cassette with the
recording/playback side facing
the cassette holder, and then
push the cassette door shut.
21 3
Press TAPE on
the player to
select the Tape
function.
Switch the system
on by pressing
POWER.
•
Rewind the cassette / DOWN
button.
•
Fast-forward the cassette UP /
button.
54
•
Side A : Tape ( ) button once.
•
Side B : Tape ( ) button twice.
Press the PUSH
EJECT ( ) of the
cassette deck to open
the cassette door and
insert a cassette.
Press the ,
button if necessary.
6
When you have
finished playback,
press STOP button.
Press the
button. The cassette
starts playing.
•
You cannot set the end point (B) within 7 seconds after
setting the start point (A).
Note
TAPE DECK