Filter
Top Products
48
System setup
When 5.1CH Surround Sound is played, you can enjoy the best sound if the distance between you and each
speaker is the same.
Since the sounds arrive at the listening position at different times depending on the placement of speakers, you can
adjust this difference by adding a delay effect to the sound of the Centre and Rear Speakers.
Setting Centre SPEAKER
If the distance of Dc is equal to or longer than the
distance of Df in the figure, set the mode as 0ms.
Otherwise, change the setting according to the table.
Distance
between
Df and Dc
0.00 m 0.34 m 0.68 m 1.06 m 1.40 m 1.76 m
Delay Time
0 ms 1 ms 2 ms 3 ms 4 ms 5 ms
Setting REAR SPEAKER
If the distance of Dc is equal to or longer than the distance of Dr
in the figure, set the mode as 0ms.
Otherwise, change the setting according to the table.
Distance
between
Df and Dc
0.00 m 1.06 m 2.11 m 3.16 m 3.62 m 5.29 m
Delay Time
0 ms 3 ms 6 ms 9 ms 12 ms 15 ms
M
With ` PL II (Dolby Pro Logic II), the delay time may be different for each mode.
With AC-3 and DTS, the delay time can be set between 00 and 15mSEC. `
The Centre channel is only adjustable on 5.1 channel discs. `
Ideal Centre SPEAKER
placement
Df: The distance from FRONT SPEAKER
Dc: The distance from Centre SPEAKER
Dr: The distance from REAR SPEAKER
It is desirable to place all speakers within this circle.
Ideal
REAR
SPEAKER
placement
Setting up the Speaker Delay Time