Filter
Top Products
63
ENG
● SYSTEM SETUP
ASC (Auto Sound Calibration) SETUP
Plug the ASC microphone into the ASC input jack.
Place the ASC microphone at the listening position.
Press ASC button.
To create the optimal 5.1 channel sound fi eld, the
selections are in the following sequence:
L ➞ C ➞ R ➞ SR ➞ SL ➞ SW
When the message "REMOVE MIC" appears in the display,
unplug the ASC microphone.
Setting the ASC function takes about 3 minutes.
To cancel the ASC (Auto Sound Calibration) setup, press ASC
button.
The tone output stops, "CANCEL ASC" appears in the display followed by "REMOVE MIC", and the
setup is cancelled.
To listen in the ASC (Auto Sound Calibration) mode, briefl y press
ASC button.
The selection alternates between ASC ON and ASC OFF in the display.
If you select "ASC ON", you will hear sound in the ASC mode.
If you select "ASC OFF", you will hear sound in the mode set in the audio setting of the setup screen.
1.
2.
3.
~
4.
M
`
HT-WZ410(TWZ412)_XAC_0219.indd 63 2008-02-20 �� 6:07:59