Filter
Top Products
17 - English
Settings
Support
Software Upgrade
For more information about this function see
page 20.
Contact Samsung
Provides contact information for assistance with
your product.
Terms of Service Agreement
View the general disclaimer regarding third party
contents and services.
Reset
Reverts all settings to their defaults except for the
network. Requires that you enter your security
PIN. The default security PIN is 0000.
Network Setup
When you connect this product to a network, you
can use network based applications and functions
such as BD-LIVE and upgrade the product's software
through the network connection.
Configuring Your Network Connection
To begin configuring your network connection,
follow these steps:
1.
In the Home screen, select Settings, and then
press the
v
button.
2.
Select Network, and then press the
v
button.
3.
Select Network Settings, and then press the
v
button.
4.
Go to the instructions for Wired networks
starting below or the instructions for Wireless
networks. (See page 18)
Wired Network
Ğ
Wired – Automatic
After following Steps 1 to 3 above:
1.
In the Network Settings screen, change
Network Type to Wired. Then, select Connect
and press the
v
button. The product detects
the wired connection, verifies the network
connection, and then connects to the network.
2.
When it is done, highlight OK, and then press
v
button.
Ğ
Wired - Manual
If you have a static IP address or the automatic
procedure does not work, you'll need to set the
Network Settings values manually.
After following Steps 1 to 3 above:
1.
In the Network Settings screen, change
Network Type to Wired. Then, select Connect
and press the
v
button.
The product searches for a network, and then
displays the connection failed message.
✎
If it is possible to connect the home cinema
to your network wirelessly, select Change
Network at this point, change the Network
Type to Wireless, and then go to the
instructions for wireless networks. (See page
18
)
Network Settings
MAC Address XX:XX:XX:XX:XX:XX
IP Address 0. 0. 0. 0
Subnet Mask 0. 0. 0. 0
Gateway 0. 0. 0. 0
DNS Server 0. 0. 0. 0
a Previous d Skip < Move " Select
IP auto setting failed. Try the following to set up the IP automatically, or set up the IP manually
by selecting IP Settings.
-
Ensure that the DHCP server is enabled on the wireless network, then unplug and plug the wireless
network in again.
- Contact your internet service provider for more info.
Wired network connection failed.
Change Network
IP Settings Retry Close
2.
Use the ◀▶ buttons to select IP Settings, and
then press the
v
button. The IP Settings
screen appears.
3.
Select the IP setting field, and then set it to
Enter manually.
4.
Select a parameter to enter (IP Address, for
example), and then press
v
. Use the number
keypad on your remote control to enter the
numbers for the parameter. You can also enter
numbers using the ▲▼ buttons. Use the ◀▶
buttons on the remote control to move from
entry field to entry field within a parameter.
When done with one parameter, press the
v
button.
5.
Press the ▲ or ▼ button to move to another
parameter, and then enter the numbers for that
parameter following the instructions in Step 4.