Filter
Top Products
16 English
English 17
02 Connections
Installing the Speakers on the Tallboy Stand
* HT-D453 only - Front Speakers
* HT-D455 only - Front/Surround Speakers
Turn the Stand Base upside-down and connect it to
the Stand.
Insert small screws (4*20, For connecting Stand & Stand
Base) clockwise into the four holes marked using a
screwdriver as shown in the illustration.
CAUTION : When you use a torque screwdriver, be
careful not to put excessive force. Otherwise, it runs
idle or can be damaged. (torque screwdriver- below 15
kg.f.cm)
Connect the upper Speaker to the assembled Stand.
Insert another large
screw (5*15, For connecting Speaker
& Stand)
clockwise into the hole on the rear of the
speaker using a
screwdriver.
This is the appearance after the speaker is installed.
Follow this steps to install other speaker.
!
Connecting The Speakers
Press down the terminal tab on the back of the speaker.
Insert the black wire into the black terminal (–) and the red wire into the red
terminal (+), and then release the tab.
Connect the connecting plugs to the back of the product by matching the
colours of the speaker plugs to the speaker jacks.
Black
Red
In case of HT-D450
Front Speaker (R)
Subwoofer
Surround Speaker (R)
Surround Speaker (L)
Front Speaker (L)
Center Speaker
* Refer to page 16 for the speakers of HT-D453/D455.
Stand
Stand
Base
Stand
Speaker
HT-D450-XU-ENG-0303.indd 17 2011-03-05 �� 11:38:04