Samsung AV-R720 Home Theater System User Manual


 
25
GB
24
OPERATION
Setting HDMI AUDIO
You can set HDMI audio settings.
Press SETUP/MENU button, and then press ENTER
button.
“SETUP MODE” appears on the display and goes into Setup Mode.
Press button to select the “HDMI AUDIO”, and then
press ENTER button.
“HDMI : AVR” appears on the display.
Press …† button to set the HDMI audio.
Each time you press this button, HDMI : AVR HDMI : TV will be selected
in turn.
1
2
3
To exit setup mode
Wait for about 5 seconds or press SETUP/MENU button.
“SETUP OFF” appears on the display and Setup Mode is exited.
AVR : Audio is played on this product.
TV : Audio is played on a TV connected to the HDMI OUT jack and no audio is
played on this product.
Setting HDMI AUDIO
This function is available when both video input and outputs HDMI.
HDMI AUDIO setting is available only when the HDMI output is
connected to a TV.
If you do not hear sound from the TV, should change the HDMI audio
output setting for your DVD PLAYER or SAT to PCM.
Before using!
Press the INPUT MODE button to select HDMI1 or HDMI2. (see page 19)
If you select Digital (Optical, Coaxial) or Analogue, the HDMI audio setting will be
deactivated.
STD : Sets DRC effect to standard.
MAX : Sets DRC effect to maximum.
MIN : Sets DRC effect to minimum.
Setting DRC
Setting DRC
(Dynamic Range Compression)
You can use this function to enjoy Dolby Digital sound when watching movies at low volume at night.
DRC compresses the audio to make the loudest sounds quieter and the quietest sounds louder.
Press SETUP/MENU button, and then press ENTER
button.
“SETUP MODE” appears on the display and goes into Setup Mode.
Press button to select the “DRC SETUP”, and
then press ENTER button.
“DRC:STD” appears on the display.
Press
…†
button to set the DRC.
Each time you press this button, DRC : STD DRC : MAX DRC : MIN
will be selected in turn.
1
2
3
To exit setup mode
Wait for about 5 seconds or press SETUP/MENU button.
“SETUP OFF” appears on the display and Setup Mode is exited.
Press DRC button.
Each time you press this button, DRC : STD DRC : MAX DRC : MIN will be
selected in turn.
Using the DRC button