Filter
Top Products
22 English
Connections
Installing the Speakers on the Tallboy Stand
Turn the Stand Base upside-down and connect it to the Stand.
Insert small screws (4x20, For connecting Stand & Stand Base) clockwise
into the four holes marked using a screwdriver as shown in the illustration.
CAUTION
When you use a torque screwdriver, be careful not to put
excessive force. Otherwise, it runs idle or can be damaged.
(torque screwdriver- below 15 kg.f.cm)
Connect the upper Speaker to the assembled Stand.
Insert another large screw (5x15, For connecting Speaker &
Stand) clockwise into the hole on the rear of the speaker using a
screwdriver.
This is the appearance after the speaker is installed.
Follow this steps to install other speaker.
1.
2.
!
3.
4.
5.
2
3
Stand
Speaker
4
Stand
1
Stand
Base
5
HT-C6930W_XAA_0914.indd 22HT-C6930W_XAA_0914.indd 22 2010-09-14 2:51:322010-09-14 2:51:32