Filter
Top Products
26
Test Tone
Use test tone to check the speaker connection status or level.
Press TEST TONE button.
•
Test signal will be automatically output as follows; F.L ➝ CEN ➝ F.R ➝ S.R
➝ S.L ➝ S.W.
•
During test tone output, press …† button to adjust the speaker output level
from -10 to +10 dB by 1 step.
To Stop Test Tone
•
Press TEST TONE button again.
√
To Automatically Output Test Tone
REMOTE CONTROL
Press SETUP button.
•
“SETUP MODE” appears on the display and enters into Setup Mode.
Press FUNCTION button 5 times.
•
“TEST-T AUTO” appears in the display.
Press SURROUND button.
•
Test signal will be automatically output as follows; F.L ➝ CEN ➝ F.R ➝
S.R ➝ S.L ➝ S.W .
•
During test signal output, press SELECT ( ) button to adjust the speaker
output level from -10 to +10 dB by 1 step.
√
MAIN UNIT
1
2
3
To Stop Test Tone
Press SETUP button 1 time.
•
“SETUP MODE OFF” appears on the display and test tone stops.
,
AV-R610 XAC ENG-1 5/5/06 14:4212:0 Page 26