Filter
Top Products
Guided Tour - UR-5/UR-5D
Front Panel
1: Power switch - Use this to turn the main power on and off. When
the receiver is on, the display section (see #5 on the next page) is lit.
2: Antenna A and B mountings - Connect the supplied antennas to
these mountings. Third-party receiver antennas should not be substitut-
ed—use only the antennas provided with your receiver.
3: Group knob - Allows you to select any of ten frequency Groups
(numbered from 0 - 9). When using the Samson UHF Synth System in a
multiuser environment (that is, when there are two or more transmitters
and receivers in use at one location), all receivers
must be set to the
same Group in order to avoid intermodulation distortion. Each individual
performer is then assigned an individual Channel within that Group
(up to eleven channels are available simultaneously*).
4: Channel knob - Allows you to select any of ten frequency Channels
(numbered 0 - 9) within the selected Group.* When a new channel is
selected, it takes approximately five seconds for audio signal to be
passed through to the receiver outputs.
* Only group 9 has more than seven available channels; all other groups
use channels 0 - 6. Refer to the UHF Frequency Chart on page 24 for
more details.
5
SAMSON
UHF SYNTHESIZED DIVERSITY RECEIVER
ANTENNA - A
UHF
Synth Series
5
4
3
2
1
0
6
7
8
9
UR-5
UR-5
GROUP
5
4
3
2
1
0
6
7
8
9
10
AF LEVEL
5
3
2
1
6
7
8
9
CHANNEL
0
ANTENNA - B
POWER
AVAILABLE / MUTE
12
34
5
12
34
5
A
B
RF LEVEL
AF LEVEL
dbx
NOISE
REDUCTION
1
2
3
4
5
2
6
12
34
5
A
B
RF LEVEL
AF LEVEL
5a
AVAILABLE / MUTE
12
34
5
5b
5d 5e 5c