30
Guided Tour - DA-5L Rear Panel
1: AC input - Connect the supplied standard 3-pin “EEC” plug here.
The DA-5L contains an automatic current and voltage sensing circuitry
and so can accept any mains current from 100 - 250 volts without the
need to set a selector switch. The AC outlet used for powering the
DA-5L
must be grounded. See the “DA-5L Grounding Techniques”
section on page 33 of this manual for more information.
2: Antenna Output (Distributor A) - Use the supplied BNC connectors
to connect each of these antenna outputs to the “Antenna A” inputs of
your receivers. For more information, see the section in this manual
entitled “Setting Up and Using the DA-5L” (on page 31).
3: Antenna Output (Distributor B) - Use the supplied BNC connectors
to connect each of these antenna outputs to the “Antenna B” inputs of
your receivers. For more information, see the section in this manual
entitled “Setting Up and Using the DA-5L” (on page 31).
DISTRIBUTOR A
12 34
ANTENNA OUTPUT 50 Ω
DISTRIBUTOR B
AC INPUT
MADE IN JAPAN
SAMSON
UHF ANTENNA DISTRIBUTION AMPLIFIER
SAMSON TECHNOLOGIES CORP.
HICKSVILLE, NEW YORK, U.S.A.
MODEL No.DA-5H
Frequency range:947MHz to 952MHz
POWER RATING
120V~ 50/60Hz 3W
(120V TO 240V VOLTAGE SENSING)
1234
ANTENNA OUTPUT 50 Ω
1
2
3