![](http://pdfasset.owneriq.net/1/cb/1cbca55d-10ce-4800-9113-73b0b1d5729c/1cbca55d-10ce-4800-9113-73b0b1d5729c-bg12.png)
16
Stacking and Tilting the C valve
Installing the Tilting Feet
You can install the tilting rubber feet included with
your C valve so that you can set the unit at a com-
fortable operating angle on a workstation or desk-
top. Follow the simple instructions below to install
the tilting feet.
• Remove the bottom screw from right front
bumper.
• Identify the right tilting foot by the locating
“R” marking on the inside top.
• Position the angled foot under the right
bumper as shown in the drawing.
• Use the included 4 x 10mm screw to attach
the foot.
• Repeat the steps above for the front left
bumper.
Stacking the C valve
You can stack one C valve, or
any other Samson C Class
units, on top of each other by
simply lining up the bumpers.
Important Note:
When stacking
the C valve, be sure that only
the bottom unit has the tilting
feet installed.