Samson RS18S Speaker System User Manual


 
RS15S and RS18S System Set-ups
This is example shows a system with a single power amplifier connecting the subs and satellites in stereo. The mixer’s left and right outputs
are connected to the inputs of the power amplifier using shielded cable. The outputs of the amplifier are connected to the RS15S or RS18S
INPUT using un-shielded speaker cable. Next, run an un-shielded speaker cable from the RS15S’s or RS18S’s EXTENSION OUTPUT to the two
satellite speakers. For details on wiring your speaker cables, see page 42 in this manual.
IMPORTANT NOTE: To avoid any possible damage to your amp and speakers, be sure to check the manufacturer’s owners manual
to confirm your power amplifier is capable of operating at 2 ohms.
RS15S and RS18S Stereo Sub with Passive Satellites




This example shows a stereo system with mono sub powered by separate amplifiers for the mid-high satellites and subwoofers. The mixer’s
left and right outputs are connected to the inputs of the mid-high power amplifier using shielded cable. Next, run un-shielded speaker cables
from that amplifier to the two satellite speakers. Now, connect the mixer’s mono output to the inputs of the sub power amplifier using shield
-
ed cable. The outputs of the sub amplifier are connected to the RS15S or RS18S INPUT using un-shielded speaker cable. For details on wiring
your speaker cables, see page 42 in this manual.


RS15S and RS18S Mono Sub with Passive Satellites
ENGLISH
10