Samson D415 Speaker User Manual


 
Owner's Manual
11
Auro D412/D415
Quick Start
The following steps will help you set up your Auro D412/D415 loudspeakers.
Setup
1. Turn the Level control on the rear panel fully counterclockwise.
2. Set the Bass and Treble EQ controls to the 12 o’clock position.
3. Turn the Power switch OFF.
Connections
1. Connect either a line-level signal from your mixer (or other source) or a microphone to the Input
jack on the Auro D412/D415 rear panel.
2. Connect the supplied power cable to the IEC socket on the back of the loudspeaker. Plug the
power cable into an AC outlet.
3. Note: Always make sure that the AC outlet is congured with the correct voltage as indicated on
the rear panel of the Auro loudspeaker.
Operation
1. Switch the Auro’s Power switch to the ON position.
2. Run an audio signal from your mixer, or talk into the microphone.
3. Slowly raise the Auro’s Level control until you have reached the desired level.
4. If the volume from the speakers gets really loud, or you see the Peak indicator blinking frequently,
turn down the Level control on the Auro D412/D415 a little until the Peak indicator does not light,
or only lights occasionally with signal peaks.
ENGLISH
FRANÇAISDEUTSCHEESPAÑOLITALIANO